This is the multi band dipole I built. I calculated the lengths of wire at the center of the band, so my SWR is pretty flat there, and at most the SWR only reaches about 2.2:1. My only mistake, that I know of is 10 meters. I cut the wires a little short, and am unable to tune the lower part of the band (below 28.450 MHz). Other than that, I am pleased with my creation. It took about a day to have this made up, and it is an easy project I think anyone can tackle.
Subscribe to:
Posts (Atom)
RaDAR Rally Report from Nov. 4, 2023
The RaDAR (Rapid Deployment Amateur Radio) Rally was 11/4/23. I decided to operate from a familiar location, Pine Log State Forest which i...
-
Over the past several weeks, I have had a blast with packet radio. I remember the days of phone line bbs's (bulletin board systems) a...
-
I've been looking for a terminal emulator program for my Raspberry Pi. I did some research and found a program called Linpac and have ...
-
Today, my wife and I had the day off and the kids had the day off from school. The weather was warm, but not too hot, which is a welcome ch...